 |
The Virtual Repairman's Appliance Help It's only expensive if someone else fixes it for you
|
| View previous topic :: View next topic |
| Author |
Message |
Virtual Repairman Site Admin
Joined: 06 Jul 1999 Posts: 4627 Location: Austin, TX
|
Posted: Sat Apr 03, 2010 5:02 am Post subject: GE Monogram ZIS Diagnostic Instructions |
|
|
ZIS "M" and "R" MODELS-
ALWAYS check that the Climate Control Drawer Control Lock is OFF before entering the Diagnostic Mode. If the Diagnostic Mode is entered with the Climate Control Drawer Lock enabled, it will be permanently enabled (hard-coded) on that Main Board upon exiting the Diagnostic Mode. If the Control Lock is accidentally left on when entering the Diagnostic Mode, the Main Power Control Board must be replaced to correct the condition.
As a side note, after exiting the diagnostic mode, ALWAYS briefly unplug or turn off the breaker to remove the unit from power, then restore the power. Failure to cycle the power will result in NO COOL due to the main board not starting the compressor. _________________ FAST-MOVING PARTS | Ask the Repairman |
|
| Back to top |
|
 |
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Please use the parts links below to support this website and keep this help free!
Any part ordered from my affiliate links can always be returned if it does not fix the problem!
Start your search here:

Diagram Search- Enter first 5 digits of model to see choices-
Powered by phpBB and The Virtual Repairman Copyright 2011 All Rights Reserved
|